Emtron ED5, Руководство пользователя

Страница: 9 / 13

EMTRON ED5 USER MANUAL WWW.EMTRON.WORLD
© EMTRON AUSTRALIA PTY LTD MARCH 2018 8
4.0 ED5 Software Installation
Download the latest version of Emtron Display Editor from:
https://emtron.world/downloads/
Install by opening the downloaded installer. Follow the instructions provided. Once the
install is complete there will be a shortcut icon on the desktop.
4.1 Installing USB Drivers
USB drivers will be installed automatically.
5.0 ED5 Device Configuration
Once the ED5 and ECU is powered and connected to the CAN bus the ECU must be
configured to send CAN packets. The ED5 is shipped pre configured with a sample
configuration file that will allow communications provided the ECU is setup to send the
correct CAN ID’s .
NOTE: The ED5 will not switch into run mode with the USB cable connected to the PC. Make
sure this is unplugged for normal operation.
5.1 Emtune Settings
Ensure the ECU firmware Version is 2.17.0. If using earlier firmware versions, the display
may still be operational however some functionality and channels will not be available.
Make sure the ECU is powered up is Online in Emtune.
Goto Config View->Communications->CAN Bus 1->CAN Bus 1 Setup->CAN 1 Baud Rate and
set to 1Mbps.