EMS Sky Connect Series, Руководство по установке

Страница: 28 / 70

1616-964-12
Date: 7/27/2011
Rev. 2.1
3.6.3 TRANSCEIVER STRUCTURAL MOUNTING
The Sky Connect Transceiver should be mounted in accordance with standard
practices found in FAA Advisory Circular 43.13-2A. The Transceiver is approved for
mounting outside the pressure vessel. See Figures 2 and 3 for unit and tray
dimensions.
The structural mount consists of a mating tray, with a self-locking, vibration
resistant, knurled thumbscrew system. The tray should be bolted to a suitable
avionics shelf, using approved #6 hardware, until the tray was changed to Mod level
A, which requires #8 hardware. Please check the Mod Status on the tray prior to
installation to assure you use the correct hardware.
Tray Mod
Level Hardware to be used
none 6-32 screw holes are provided, if required, these may be drilled
oversize to accommodate 8-32 screws.
A 8-32 screw holes are provided. If replacing this tray in place of
an older tray with 6-32 screws, use the 6-32 screws with
washers.
The 62 pin High Density D-subminiature connector and 1 to 2 antenna connectors
are all that is required to electrically connect the box once it has been structurally
secured in place.
3 - 8