POWER
FAULT
ISOLATOR
ACTIVE
F
usion
Loop Module
Loop Module
Installation Guide
©2014 EMS Radio Fire & Security Systems Ltd. All rights reserved 1/2 TSD077 Iss 3c 15/04/14 AJM
FCX-532-001
FCX-532-002
Fusion Loop Module
Fusion Loop Module c/w Remote Aerial Facility
POWER
FAULT
ISOLATOR
ACTIVE
F
usion
F
usion
Loop Module
Part No Product Description
Step 1
Pre Installation
!
The Fusion Loop Module installation must conform to
applicable local installation codes and should only be
installed by a fully trained competent person.
The following points require consideration upon installation:
Loop Module location. Refer to the design drawings generated
from the radio survey.
Radio performance. Refer to step 3 to ensure the radio
performance is optimised.
Remote aerials. If using remote aerials with this product, refer
to the Remote Aerial Installation manual for more information.
A maximum of 5 Loop Modules can be connected per loop.
Step 2
Loop Module Components
1
2
3
4
5
4X Corner
covers
4x Lid
Screws
1x Loop
Module Lid
1x Loop
Module PCB
1x Loop Module
Back Box
Part Description
Item No
1
2
3
4
5
FIRE
Fire Alarm Control
Step 3
Mounting Location Guidelines
Ensure the Loop Module is
not installed within 2m of
other radio or electrical
equipment (not including
the Control Panel).
Ensure the Loop Modules
aerials are not installed
within 0.6m of any metal
work.
POWER
FAULT
0.6m
To ensure the
optimum range
performance of
the Loop Module
is achieved, the following
should be considered:
2m
Control
Panel
Loop
Module
Step 4
PCB Removal
The internal PCB of the Loop Module can be removed to ensure that
damage is not caused during installation.
Remove the central retaining screw prior to unclipping the PCB.
WD
BACK
POWER
FAULT
ISOLATE
0V
RX
TX
3V
SCR
+
-
LOOP IN
SCR
LOOP OUT
+
-
Fit the Back Box
to the wall.
All five circled
fixing positions
are available for
use.
Step 6
Fit Loop Module Back Box to the Wall
Step 5
Prepare the Loop Module Back Box
Drill the required
cable entry points
where necessary.
= Do Not Use
= Available Cable
Entry Points
ATTENTION
OBSERVE PRECAUTIONS
FOR HANDLING
ELECTROSTATIC
SENSITIVE
