28095-6-0115
Page 10
NOTICE
:
all flames will be random by design, flame height will go
up and down.
During manufacturing, fabricating and shipping, various components
of this appliance are treated with certain oils, films or bonding agents.
These chemicals are not harmful, but may produce annoying smoke
and smells as they are burned off during the initial operation of the
appliance, possibly causing headaches or eye or lung irritation. This
is a normal and temporary occurrence.
The initial break-in operation should last 2-3 hours with the burner
at the highest setting. Any odors remaining after this initial break-in
will be slight and will disappear with continued use.
PerIodIc cleanInG – refer to parts diagram for location of
items discussed below.
•
Do not use cleaning fluid to clean any part of heater.
•
Remove loose particles and dust from the burner areas,
controls, covers and grate.
•
Inspect and clean burner air intake hole. Remove lint or particles
with brush. Failure to keep air intake hole clean will result in
sooting and poor combustion.
annual cleanInG/InsPectIon – refer to parts diagram for
location of items discussed below.
•
Inspect and clean burner air intake hole. Remove lint or particles
with vacuum or brush. Failure to keep air intake hole clean will
result in sooting and poor combustion.
•
Inspect and clean all burner ports.
•
Inspect pilot for operation and accumulation of lint at air intake
holes.
•
Verify flame pattern and log placement for proper operation.
•
Verify smooth and responsive ignition of main burner.
reMoVInG tHe Burner toP
•
Grasp front left and right corners of the burner.
•
Lift upward to release the corners from the bottom.
•
Slide the top to the right and lift up the rear burner top.
BATTERY InSTALLATIon
•
Install the provided batteries into the hand held transmitter and
receiver.
receIVer InstallatIon
•
Install the receiver to the right of the large opening in burner
bottom.
Millivolt - Figure 3
oPeratIon InstructIons/FlaMe aPPearance