26996-7-0411
Page 14
ALTERNATE ON/OFF SWITCH INSTALLATION
WIRING THE FIREpLACE
NOTICE: Electrical wiring must be installed by a licensed
electrician.
CAUTION
DISCONNECT REMOTE CONTROLS IF YOU ARE ABSENT
FOR EXTENDED TIME PERIODS. THIS WILL PREVENT AC-
CIDENTAL FIREPLACE OPERATION.
Installation of Alternate Surround panel ON/OFF Switch
An ON/OFF switch and wire assembly are provided. They are in-
cluded in the instruction packet.
Do not cut wire or insulation on metal edges.
NOTICE: Refer to surround panel installation section on page
15 for additional information on attachment.
Contemporary Surrounds
1. Find the coiled low voltage wire assembly and ON/OFF switch
located in the instruction packet.
2. Attach the flag terminal ends to the “TH/TP” and “TH” termi
-
nals on the front terminal block of the gas valve.
See Figure
13.
3. Run the low voltage alternate switch wires up the back of the
right or left surround panel. Then secure the wires with wire
clips provided.
See Figure 11.
Figure 11
Insert ON/OFF switch into side panel then attach wire assem-
bly from valve terminals.
4. Remove the switch knockout on the side surround panel, then
install the ON/OFF switch.
5. Connect the low voltage wires from the gas valve to the
ON/OFF switch.
6. Attach the surround panel assembly to the insert. Place the
surround panel assembly against the face of the insert and
align the lower retaining tabs with the notches on the insert
sides. Lift the surround panel assembly slightly until the bot-
tom return flange (top panel) is positioned over the top flange
on the insert. This secures the surround panel assembly to
the insert without screws.
Traditional Cast Iron Surrounds
WIRING FROM
MILLIVOLT GAS
VALVE
ON/OFF
SWITCH
ASSEMBLY
Right Side Installation
Left Side Installation
ON/OFF
SWITCH
ASSEMBLY
1. Find the coiled low voltage wire assembly and ON/OFF switch
located in the instruction packet.
2. Attach the flag terminal ends to the “TH/TP” and “TH” termi
-
nals on the front terminal block of the gas valve.
See Figure
13.
Figure 12
NOTICE: For right side leg installation, reverse switch posi-
tion in bracket.
3. Run the low voltage alternate switch wires up the back of the
right or left cast surround leg. Then secure them with the wire
clips provided.
4. Install the switch bracket with screws as shown in
Figure 12
to the back of the cast surround leg.
5. Install ON/OFF switch, and connect low-voltage wires from
gas valve.
6. Attach cast surround panel assembly to the insert. Place the
cast surround assembly against the face of the insert and
align the lower retaining tabs with the notches on the insert
sides. Lift the cast surround assembly slightly until the bottom
return flange (top panel) is positioned over the top flange on
the insert. This secures the cast surround assembly to the
insert without screws.
Figure 13
