Emperor PWCRO, Руководство пользователя

Страница: 22 / 60

Electrical Connections
Main System Power
The main power on the Whole House RO system is available in 220 volt, 60 Hertz, 1
Phase. Each Whole House RO system is equipped with a 5 foot electrical cord. This can
be hardwired in a disconnect box or an outlet box can be installed that matches the cord
end for the respective voltage. This should be powered by an isolated 20 amp breaker.
Re-Pressurization Pump
The re-pressurization pump requires 110 Volt, 60 Hertz, 1 Phase. This should be con-
nected to a constantly energized 110 Volt outlet. The pump is equipped with a standard
110 Volt cord end.
UV Light Controller
The UV Light Controller requires 110 Volt, 60 Hertz, 1 Phase. This should be connected
to a constantly energized 110 Volt outlet.
IMPORTANT NOTICES
WARNING: To prevent possible circuit overload, it is best to run isolated circuits to
supply the RO system and the UV Light and Re-pressurization pump
The RO system should have a 20 Amp Breaker. The UV Light and Re-pressurization
pump can share a 20 Amp Breaker.
NOTE: It is recommended that a licensed electrician wire the system in accordance
with the local and national electrical codes.
WARNING: To reduce the risk of electrical shock, the incoming power supply must
include a protective earth ground.
NOTE: If the anti-scalant option was purchased, the injection check valve that
comes with the anti-scalant pump should be put in the injection tee on the booster
pump inlet plumbing. There is a 1/2" plug that must be removed and the injection
check valve can be installed.
BE SURE to Teflon tape the injection check valve threads before installing it in the
tee fitting.
22