Before beginning installation, to better handle the hood, we advise removing
the aluminum filter.
Before fixing, the outlet exhaust duct for air evacuation to the outside must
be installed. Use an outlet exhaust duct with: - minimum indispensable
length; -Minimum possible bends (maximum angle of bend: 90°); -certified
material
(according to local, building & fire
regulations); and as smooth as possible
inside. It is also advisable to avoid any drastic
changes in duct cross-section
(recommended diameter:
125mm).
Drill the hole in the wall for the air outlet (133
mm diameter) referring to drawings here on
the right where the measurements for the
various possibilities are indicated.
Decide on the position of the hole for the air
outlet: The hole must be in the ceiling,
according to your requirements, but must be in
vertical line with your hood. Bear in mind that
the hood can expel air through the top air
outlet only.
Fitting under wall unit
1.
Before fixing the hood to the wall unit, drill a hole of 130mm diameter
in the wall unit.
2.
In any case, check the position of the
power outlet considers where the power
cable will run, since a hole might have to
be made in the wall unit to accommodate
it.
3.
Drill 4 holes in the wall unit,
5
Содержание CK60FRF
