0.025
LOG FREQ (kHz)
10
10 dB/div
Dimensions:
.975
.650
0.025
LOG FREQ (kHz)
10
10 dB/div
INPUT
GROUND
GROUND
OUTPUT
V++
SPC / RPC
SPECIFICATIONS
Input Impedance (Ohms)
250K
Input Referred Noise
-130dbV
Output Impedance (Ohms)
2K
Current @ 9V (Microamps)
980
Battery Life (Hours)
250
Maximum Supply (Volts DC)
18
INSTALLATION INFORMATION
EMG MODELS:
SPC / RPC
(ACTIVE/PASSIVE PICKUP INPUTS)
Warranty
All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If
upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This
warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.
© 2014 Copyright EMG INC. All Rights Reserved.
PO BOX 4394
SANTA ROSA, CA
95402 USA
P (707) 525-9941
F (707) 575-7046
EMGPICKUPS.COM
0230-0160rB
Frequency Response:
EMG-SPC
1.325
.400
.309 (8mm P .75)
GENERAL OPERATION:
The SPC and RPC are active EQ circuits for guitar. The SPC is a mid-range boost. The RPC is a low cut/high boost.
The graphs below illustrate the effects of the controls. The thick black line displays the effect with the control all the way up (clockwise).
The flat black line illustrates the effect with the control all the way down (counter-clockwise) in the bypass mode. The controls are continuously
variable from flat to maximum effect. The SPC and RPC are wired in series with the signal path, so there is an input and output.
Both controls feature buffered inputs and can be used with passive pickups.
Connector for EMG Active Tone controls
and accessories.
Pin 1
Input
Pin 2
Ground for Input
Pin 3
Ground for Output
Pin 4
Output
Pin 5
V+ Supply
EMG-RPC
1
2
3
4
5
1 2 3 4 5
INCLUDED:
1 SPC or RPC Control
1 Battery Clip with Buss Connector
1 Stereo Output Jack (Battery Switching)
2 Interconnect cables
