.390
(10)
(6)
(8)
.235
.310
INSTALLATION INFORMATION
EMG MODELS:
P-HZ
Warranty
All EMG Pickups and accessories are warranted for a period of two years. This warranty does not cover failure due to improper installation, abuse or damage. If
upon examination the pickup is determined to be defective, a replacement will be made. Warranty replacement products are covered by this same warranty. This
warranty covers only those pickups and accessories sold by authorized EMG Dealers. This warranty is not transferable.
© 2018 Copyright EMG INC. All Rights Reserved.
PO BOX 4394
SANTA ROSA, CA
95402 USA
P (707) 525-9941
F (707) 575-7046
EMGPICKUPS.COM
0230-0266rF
(1) Loaded with 500K Volume and Tone
and 20’ (6M) 560pf cable
(2) Loaded with 1 MegOhm / 47pf
SPECIFICATIONS
MODEL
:
P-HZ
Logo Color
Gold
Magnet
Type
Alnico
5
Inductance
(Henries)
6.12
DC Resistance (kOhm)
11.20
Resonant Frequency (KHz) (1)
1.77
Resonant Frequency (KHz) (2)
2.36
Impedance at Resonance (kOhm) (1)
68.00
OUTPUT CABLE 6” (15cm)
CONNECT CABLES 5.5” (14cm)
BRIDGE GROUND WIRE 6” (15cm)
P PICKUP CABLE 12” (30cm)
#4 PHILLIPS RH WOOD SCREWS
FOR MOUNTING
2.250
2.250
2.450
2.450
1.100
1.100
R .125 TYP
R .125 TYP
LOGO SIDE IS FOR
D AND G STRINGS
Installation notes:
As you can see from the diagram above, the P Set consists of two pickups. Both pickups are identical in size and shape. Either can be used
for the E/A Strings or the D/G Strings. The only difference between them is the connector on the bottom of the pickup.
All EMG-HZ Pickups are compatible with each other. The connector system is an easy method of installation, avoiding the need to solder.
EMG Accessory Circuits like the VLPF, EXB, BTC or BQC Controls can be added to any EMG Pickup System, all have buffered inputs and can
be used on either passive or active pickups. The B157 Buss included with the set will be used on instruments that use a selection switch.
IMPORTANT NOTE:
It is common practice to ground (earth) the strings of an instrument that uses passive pickups to reduce noise. This means there will be a wire
coming from the bridge into the control cavity that will be hooked to one of the pots. Included with the EMG-HZ System is a single black wire
with a connector on it and an IDC connector that will attach to the existing ground wire and will provide the ground (earth) connection.
(57.1)
(57.1)
(27.9)
(27.9)
R .234 TYP
R .234 TYP
(62.2)
(62.2)
(3.17)
(3.17)
(5.9)
(5.9)
1 VOLUME CONTROL (250K)
1 TONE CONTROL (250K)
ADJUSTMENT SCREWS(4)
MONO OUTPUT
JACK
BRIDGE GROUND
CONNECTOR
Included with each pickup:
