7
MicroVission Retrofit Instructions • 35391MVRF
Figure 5. Tri-Micro filter with
pressure transducers
Step 6
. Install the 4-20mA current transmitter to sense the amperage at the motor terminal box, and connect to the
analog input at the MicroVission panel.
Figure 6. Connection of 4-20mA Current Transmitter (Sensor)
NOTE
The Keypad and VILTech Micro-controllers did not have
an amperage input, and the Vantage used a different
type CT, so the acquisition of current transmitter (VPN
3669CT) is imperative to work with the MicroVission
panel. This transmitter is contained in retrofi tting kit
KT24X20MV, see Table 2.
Step 7.
Go to section 3.0 for wiring instructions.
Содержание Vilter MicroVission
Страница 1: ...MicroVission Controller Retrofit Guide ...
