Emerson Rosemount Ultrasonic 3410 Series, Руководство пользователя

Страница: 19 / 80

Figure 2-7: Acquisition Module Wiring
9. Route the transducer cables through the cable glands with the
correct label number (i.e. A1) which matches the label on the
transducer cable.
Figure 2-8: Base Enclosure Cable Glands Installation
10. Judge the proper length and cut off the excess.
11. Strip the outer insulation, outer shield, and inner insulation using a
utility knife. Verify that insulation of individual wires was not cut
while removing outer layers. Strip each wire 0.28-in.
Figure 2-9: Transducer Cable Cut Instructions
February 2022 Upgrade kit instructions
Upgrade kit instructions 19