Emerson Rosemount ET310, Быстрый старт

Страница: 35 / 52

2. Remove the CC21 and fit the power module, tightening the two
power module retaining bolts. Refer to the Rosemount BP20E Power
Module for Wireless Corrosion Transmitter Quick Start Guide .
When the power module is fitted, the sensor automatically restarts
and tries to join the
Wireless HART
®
Gateway. In a large network of
100 sensors this can often take two hours, and sometimes up to six
hours.
4.6 Fitting the lanyard for a magnetic fixture install
WARNING
Two lanyards must be used to restrain the sensor and the magnetic mount
from accidentally falling.
If each lanyard is not long enough, two lanyards can be linked together. For
this reason 4 lanyards are supplied with each magnetic mount.
Procedure
1. Find a suitable attachment point for the lanyard that is as short a
distance as possible, vertically above the mounting location.
2. If the distance does not allow for an individual lanyard to reach the
attachment point, use the loop in one lanyard to link two lanyards
together.
3. Thread the bare end of the wire around the fixing point and through
the loop in the lanyard to secure the lanyard.
4. Feed the end of the lanyard into the cable lock and pull a length
through.
5. Feed the end of the lanyard through the frame of the magnetic
fixture as displayed in Figure 4-9 .
6. Then feed the end through the strap slot of the sensor and into the
return hole of the cable lock.
7. Adjust the position of the cable lock to reduce slack in the lanyard
cable; however, do not pull the cable tight.
WARNING
If the slack is not minimized and the magnetic mount accidentally
falls, the lanyard could snap, resulting in the assembly falling from a
height that could result in serious injury.
January 2022 Quick Start Guide
Quick Start Guide 35