Emerson Rosemount 5600 Series, Справочное руководство

Страница: 85 / 128

85
Reference Manual
00809-0100-4024, Rev CA
HART Configuration
March 2020
HART Configuration
Figure 5-7. Advanced Configuration
5.4 Handheld communicator
Commissioning consists of testing the transmitter and verifying
transmitter configuration data. The Rosemount 5600 Series can be
commissioned either before or after installation.
To commission, connect the transmitter and the Communicator. Make
sure the instruments in the loop are installed according to intrinsi-
cally-safe or nonincendive field wiring practices before connecting a
communication in an explosive atmosphere. Connect Communicator
leads at any termination point in the signal loop.
To enable communication, a resistance of at least 250 ohms must be
present between the Communicator loop connection and the power
supply. Do not use inductive-based transient protectors with the
Rosemount 5600 Series.
When using a handheld Communicator, any configuration changes made must be sent to the
transmitter by using the “Send” key (F2). AMS configuration changes are implemented when the “Apply”
button is clicked. See Figure 3-7 , Figure 3-8 , Figure 3-9 , and Figure 3-10 on page 62 to connect the
Communicator and transmitter.
For more information on the 275 HART Communicator see document 00275-8026-0002 and for the 375
Field Communicator see document 00375-0047-0001.