Emerson Rosemount 5408, Справочное руководство

Страница: 92 / 274

c. Under Message 1 Broadcast , select
Wired HART Enabled
.
d. Under Burst Command , select
PV, SV, TV, QV
, and then select
Next
.
e. Under Burst Msg Trigger Mode , select
Continuous
, and then select
Next
.
f. Set the Update Period, and then select Finish .
5. Prior to exiting the configuration, note the selected variables for SV, TV, and QV,
and the units set for each of the variables. The same configuration must be used for
the Rosemount 333.
Refer to the Rosemount 333 HART Tri-Loop Reference Manual for full information
about installing and configuring the Rosemount 333.
5.10 Write protect a transmitter
5.10.1 Write protect a transmitter using Rosemount Radar
Master Plus
The transmitter can be write protected (with or without a password) to prevent
unauthorized changes.
Prerequisites
If the Rosemount 5408:SIS is configured for use in Safety (SIS) operational mode, then the
Safety Mode must be enabled for the transmitter to become operational. When Safety
Mode is enabled, the transmitter is write protected to prevent unauthorized changes.
Procedure
1. Under Overview , select Device Information
→
Alarm and Security .
2. Under Write Protection , select Change and follow the on-screen instructions.
5.10.2 Write protect a transmitter using AMS Device Manager
and handheld communicator
The transmitter can be write protected (with or without a password) to prevent
unauthorized changes.
Prerequisites
If the Rosemount 5408:SIS is configured for use in Safety (SIS) operational mode, then the
Safety Mode must be enabled for the transmitter to become operational. When Safety
Mode is enabled, the transmitter is write protected to prevent unauthorized changes.
Procedure
1. Select Configure
→
Manual Setup
→
Device Setup
→
Security .
2. Under Security , select
Change Write Protection
and follow the on-screen
instructions.
Configuration Reference Manual
February 2020 00809-0100-4408
92 Reference Manual