Emerson Rosemount 326L, Быстрый старт

Страница: 35 / 52

Set output logic for switching outputs
Follow these steps to set the output logic for switching outputs.
Procedure
1. Select P-n from the menu.
2. Set PnP or nPn .
Set response of the outputs in case of fault
Follow these steps to modify how an output responds to faults.
Procedure
1. Select
FOU1
to modify the response for output 1 or
FOU2
to modify the response
for output 2 from the menu.
2. Set a value:
• On : Output switches ON in case of a fault.
The analog output switches to a value of greater than 21 mA in case of a fault.
• OFF : Switching output switches OFF in case of a fault.
The analog output switches to a value of less than 3.6 mA in case of a fault.
Fault examples
• Defective hardware
• Signal quality too low
Note
The level transmitter does not consider overflow to be a fault.
Set damping for measured signal
Follow these steps to set the damping time for a measured signal.
Procedure
1. Select dAP from the menu.
2. Set damping in seconds.
The setting range is between 0.0 to 60.0 seconds.
For more information, see Damping function .
Set delay time in case of a fault
Follow these steps to set the delay time after which the level transmitter identifies a fault.
Procedure
1. Select
dFo
from the menu.
2. Set a value between 0.0 and 10.0 seconds.
Quick Start Guide Operation
00825-0100-4326 January 2019
Quick Start Guide 35