Emerson Rosemount 2051 Wireless Series, Справочное руководство, Страница: 14 / 250

6
Reference Manual
00809-0100-4102, Rev AA
Section 2: Configuration
June 2012
Configuration
2.2.1 Warnings ( )
2.3 Required Bench Top Configuration
Bench top configuration requires a Field Communicator, AMS, or any WirelessHART
Communicator. Connect the Field Communicator leads to the terminals labeled “COMM” on the
terminal block. See
Figure 2-1 on page 7 .
Bench top configuration consists of testing the transmitter and verifying transmitter
configuration data. 2051 Wireless transmitters must be configured before installation.
Configuring the transmitter on the bench before installation using a Field Communicator, AMS,
or any WirelessHART Communicator ensures that all network settings are working correctly.
When using a Field Communicator, any configuration changes made must be sent to the
transmitter by using the “Send” key (F2). AMS configuration changes are implemented when
the “Apply” button is clicked.
AMS Wireless Configurator
AMS is capable of connecting to devices either directly, using a HART modem, or wirelessly via
the Smart Wireless Gateway. When configuring the device, double click the device icon or right
click and select Configure.
2.3.1 Connection Diagrams
Bench Hook-up
Connect the bench equipment as shown in Figure 2-1 , and turn on the Field Communicator by
pressing the ON/OFF key or log into AMS. The Field Communicator or AMS will search for a
HART-compatible device and indicate when the connection is made. If the Field Communicator
or AMS fail to connect, it indicates that no device was found. If this occurs, refer to
Section 6:
Troubleshooting .
Explosions can result in death or serious injury.

Before connecting a Field Communicator in an explosive atmosphere, make sure the
instruments are installed in accordance with intrinsically safe or nonincendive field
wiring practices.
Electrical shock can result in death or serious injury.

Avoid contact with the leads and terminals. High voltage that may be present on leads
can cause electrical shock.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
conditions: This device may not cause harmful interference this device must accept any
interference received, including interference that may cause undesired operation.
This device must be installed to ensure a minimum antenna separation distance of 20cm
from all persons.