18
ETL Model No.: CF630
7. Wall Control Procedures
7.1
Your Emerson Ceiling Fan/Light Control consists of
SW406 Wall Mounted Transmitter and a Receiver
located inside the motor assembly. The SW406 Wall
Control is designed to remotely operate your ceiling fan
speed, light intensity and direction of rotation.
Code switches in the SW406 Wall Control Transmitter
may be set in 32 different positions. If your fan and light
turn on and off without using your control, you may be
getting interference from other remote units such as
garage door openers, car alarms or security systems.
To remedy this situations, simply change the code
switches in your SW406 Wall Control Transmitter per
the instructions of Section 7.2.
7.2
Your SW406 Wall Control has code switches which
must be set in one of 32 possible code combinations
(Figure 30). The five levers (numbered 1, 2, 3, 4, and 5)
on the switches are factory-set in the ON (up) position.
Change the switch settings as follows:
NOTE: Do not duplicate the code of an existing
control of an installed ceiling fan within 100 feet.
7.3
Slide the five switch levers in the SW406 Wall Control
to your choice of ON (up) or down positions. Use a ball-
point pen or small screwdriver and slide the levers
firmly up or down.
7.4
The sixth switch marked ON and I is for dimming
control of lights: Set switch to ON to allow for dimming
of the lights. Set switch to I for no dimming of the lights
such as for fluorescent bulbs and non-dimming CFLs.
The sixth switch is factory set to the I position.
Non-dimming CFL bulbs are supplied with your fan.
7.5
Preset Memory Feature:
Your Emerson Ceiling
Fan/Light Control is equipped with a preset memory
feature. When the electricity supply to the fan is
switched OFF, the control will remember the light
intensity and fan speed. When the switch is turned back
ON, the light and fan will resume operation as they
were prior to the switch being turned OFF.
SW406 WALL CONTROL
CODE SWITCHES
ON
1
2
3
4 5
I
CODE
SWITCHES
SW406 WALL
CONTROL
Figure 30