Capillary viscosity retrofit
Figure 2-3:
2.3
Install thermal insulation
Prerequisites
Make sure you have tightened the fitting nut.
Procedure
1.
Slowly pressurize the system and check for leaks, particularly if the normal operating
temperature is high, or the meter has been fitted cold. Tighten as necessary.
2.
Tighten the nut again, if necessary.
3.
Verify that the system has stabilized and is leak free.
4.
Fit the insulation material.
Related information
Temperature gradients and insulation
2.4
Rotate the electronics on the meter (optional)
You can rotate the transmitter on the meter up to 90°.
1.
Using a 4 mm hex key, loosen the cap screw that holds the transmitter in place.
Mounting
Installation Manual
17
