Emerson Micro Motion 4200, Руководство по конфигурации и использованию

Страница: 13 / 224

Tip
The transmitter does not adjust for Daylight Savings Time. If you observe Daylight Savings Time, you
must reset the transmitter clock manually.
4. Set the month, day, and year.
The transmitter tracks the year and automatically adds a day for leap years.
2.6 View the licensed features
Display
Menu
>
About
>
Licenses
>
Licensed Features
ProLink III Device Tools > Device Information > Licensed Features
Field Communicator Overview > Device Information > Licenses
You can view the licensed features to ensure that the transmitter was ordered with the required features.
Licensed features are purchased and available for permanent use. The options model code represents the
licensed features.
A trial license allows you to explore features before purchasing. The trial license enables the specified features
for a limited number of days. This number is displayed for reference. At the end of this period, the feature will
no longer be available.
To purchase additional features or request a trial license, document the Unique ID Number and current
license key from your transmitter and contact customer service. To enable the additional features or trial
license, you will need to install the new license on the transmitter.
2.7 Set informational parameters
Display Menu > Configuration > Device Information
ProLink III Device Tools > Configuration > Informational Parameters
Field Communicator
Configure
>
Manual Setup
>
Device
You can set several parameters that identify or describe the transmitter and sensor. These parameters are not
used in processing and are not required.
Procedure
1. Set informational parameters for the transmitter.
a) Set Transmitter Serial Number to the serial number of your transmitter.
The transmitter serial number is provided on the metal tag that is attached to the transmitter
housing.
b) Set Descriptor to any desired description of this transmitter or measurement point.
c) Set Message to any desired message.
d) Verify that Model Code (Base) is set to the base model code of the transmitter.
Configuration and Use Manual Quick start
MMI-20048166 April 2019
Configuration and Use Manual 13