Emerson HIGHPOINTE CF205BS00, Руководство пользователя, Страница: 4 / 20

2.
Remove the fan motor/housing
assembly from the protective plastic
bag. Place the fan assembly into the
lower foam pad with the bottom of the
motor facing up.
The lower foam pad serves as a holder
for the fan during the first stages of
assembly.
General
Your Emerson Ceiling Fan/Light Wall
Control consists of a wall mount transmit-
ter and a receiver. The SW102 transmitter
works in conjunction with the receiver. The
receiver is mounted under the fan ceiling
cover. The wall control is designed to sep-
arately control your ceiling fan speed and
light intensity.
Code switches in the wall control and
receiver may be set in 16 different posi-
tions. If your fan and light go on and off
without using your control, you may be
getting interference from other transmit-
ters such as garage door openers, car
alarms or security systems. To remedy this
situation, simply change the combination
code in your wall control and receiver.
4
Turning off wall switch is not suffi-
cient. To avoid possible electrical
shock, be sure electricity is turned
off at the main fuse or circuit breaker
box.
!
WARNING
U.L. Model No.: CF205
ON
1 2 3 4
WALL CONTROL
LEVERS
RECEIVER
HI
HI
MED MED
LOW
LOW
FAN OFF
LIGHT
ON
1 2 3 4
RECEIVER SWITCH
LEVERS
CODE
SWITCH
SW102 WALL
CONTROL
Figure 1
Your SW102 Fan/Light Wall Control and
Receiver have code switches which must
be set in one of 16 possible code combi-
nations. The four levers (numbered
1, 2, 3, and 4) on the switches are factory-
set in the ON (up) position. Change the
switch settings as follows:
1.
Slide the four switch levers in the wall
control to your choice of ON (up) or
down positions. Use a ball-point pen or
small screwdriver and slide the levers
firmly up or down (Figure 1).
2.
In the receiver, slide the four switch
levers to the same positions as set in
the wall control. Make sure the levers
on both switches are in the same posi-
tions, otherwise the fan will not operate.
Setting Operating
Frequency of Wall
Control and Receiver
The SW102 Fan/Light Wall Control
transmits the command signals via
radio waves to the receiver installed in
the ceiling fan ceiling cover. The
receiver is required for the SW102 wall
control to function. Power for the
SW102 wall control comes from the
12V battery, located in the wall control.
Replacement 12V battery recommend-
ed are Duracell MN21 and Eveready
A23.
1.
Install the 12V battery (supplied) into
the wall control (Figure 2).
2.
The SW102 wall control is supplied
with a white, ivory or almond color
cover. Choose the style that best suits
your needs and snap the cover onto
the wall control (Figure 2).
Battery Installation
of Wall Control
BP7375 Highpointe 12/9/08 11:08 AM Page 4