Emerson FloBoss S600, Инструкция по эксплуатации

Страница: 70 / 108

S600 Instruction Manual
Note
:
While in Change mode, you can use ◄ to delete digits or
characters by backspacing over the displayed data. You can also
press
Clear
at any time to abort the current operation or task.
3.
If the data page has multiple parameters, select the required
parameter using
▲ and ▼ .
4.
Press
CHNG
. The
Enter Code
prompt displays.
5.
Key in your security code and press
Enter
.
Note
:
The S600 does not display the actual code, but displays a dot
to indicate each digit as you key it.
6.
When the prompt displays, press the appropriate numerical key (1
to 8) to select the new calculation mode.
7.
A Confirm screen displays, showing your new selection. Press
1
to
accept or
2
to reject the change. S600 redisplays the original
selection screen showing your change.
Note
:
If the data page has only one changeable data item, S600
automatically exits the edit sequence when you either accept
or
reject the value change.
5.7.4 Assigning a Default Page
If you have a specific activity to perform that requires you to
temporarily use a particular menu or data display page, use this
procedure to set that menu or data display page as the temporary
default S600 display.
To define the default display using the Minus (
–
) key:
1.
Go to the required data display page.
2.
Press
Minus
.
3.
Press
Minus
again to confirm the selection.
To clear the default display, go to a menu page and repeat steps 2 and
3. To invoke the default display, use the
CLEAR
key.
Note
:
The
CLEAR
key does not work while in Edit mode.
5.7.5 Assigning a Page to a Function (F) Key
You can assign any display page to appear when you press one of the
four function keys (F1 through F4). This is helpful when you often
need quickly to access a particular page.
1.
Access the desired display page.
2.
Press the Decimal Point (
.
) key.
3.
Press the F key—F1, F2, F3, or F4—you want to associate with
that display page.
5-10 Front Panel Revised Jan-07