Emerson Dixell XEV20D, Краткое руководство пользователя, Страница: 5 / 5

1592025980 XEV20D GB r.2.7 31.07.2019 XEV20D 5/5
9. SERIAL -- CAN BUS LINE
The device can communicate via CAN Bus serial only once an appropriate module
address has been set. The address is set by the dip-switch, named
Address ,
according to the following drawing:
The address is set in binary mode. Each
selector has an increasing weight, in the
figure the set address is:
1 x 1 = 1
2 x 0 = 0
4 x 1 = 4
8 x 1 = 8
➔
1+4+8=13
NOTE: To set properly the ISaGRAF® software, refer to the documentation on
https://www.ipro.academy website.
10. MEANING OF THE LED LIGHTS
The following table illustrates LED light operation.
LED MODE MEANING
PWR ON On The instrument is powered correctly
ALARM On There is an alarm
TX/RX Blinking
CAN Bus or LAN activity, communication
enabled
TX/RX On No link
OPEN V1 Blinking Valve 1 in opening mode
OPEN V1 On Valve 1 fully open
CLOSE V1 Blinking Valve 1 in closing mode
CLOSE V1 On Valve 1 fully closed
OPEN V2 Blinking Valve 2 in opening mode
OPEN V2 On Valve 2 fully open
CLOSE V2 Blinking Valve 2 in closing mode
CLOSE V2 On Valve 2 fully closed