11
emersonfans.com
Please contact 1-800-654-3545 for further assistance
U.L. Model No.: CF1
Using Your Ceiling Fan
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
WARNING
!
To install an accessory light kit, first unscrew the finial
and remove the lower trim (Figure 18). Then remove
the center trim by removing four 8-32 x 1/2” screws.
Remove the threaded nipple from the center trim and
install the light kit in accordance with the light kit
Owner’s Manual.
Attaching Light Kit
REVERSING
SWITCH
SPEED
CONTROL
PULL CHAIN
SWITCH
Figure 17
SPEED
CONTROL
PULL CHAIN
SWITCH
THREADED NIPPLE
LOWER TRIM
FINIAL
8-32 x 3/8"
SCREW (4)
CENTER
TRIM
Figure 18
1.
Restore electrical power to the outlet box by turning
the electricity on at the main fuse box.
2.
Check the operation of the fan by gently pulling on
the 4-position speed control pull chain switch (Figure
17). The operating sequence is as follows:
3.
If airflow is desired in opposite direction, turn your
fan off and wait for the blades to stop turning, then
press the rocker switch located on top of the motor
housing, and turn the fan on again. The fan blades
will turn in the opposite direction and reverse
airflow.
Your fan model is equipped with a 4-position,
3-speed pull chain switch. The operating sequence
is as follows:
Three-Speed
1st Pull—HIGH
2nd Pull—Medium
3rd Pull—Low
4th Pull—OFF
