Emerson Copeland EazyCool ZXDI Series, Инструкции по применению, Страница: 65 / 70

C6.1.10/0118-0318/E 60
Appendix 6: Additional features for customization
Required setting for proper functionality Setting needs to be adjusted according to application
Temperature sensor in case temperature
– System restart is required!
Parameters
Parameter description Factory setting Required setting
ZXDE ZXDI
A19 P7C Probe 7 configuration nu = Not used tnt = Thermostat temperature
C05 LS Compressor regulation probe selection
SuP = Suction pressure
probe
CSt = Case temperature
G01 EcS Case temperature probe selection nu = Not used tnt = Thermostat temperature
G02 SEt Cut-out temperature +2°C Adjust to application requirements
G03 Hy Positive differential defines upper cut-in temperature 1K Adjust to application requirements
Unit On/Off
– System restart is required!
Parameters
Parameter description Factory setting Required setting
ZXDE ZXDI
R07 i3F Digital input 3 configuration nu = Not used OnF = On/Off
R08 i3P Digital input 3 polarity CL = Closed Adjust to application requirements
Evaporator fan
– System restart is required!
Parameters
Parameter description Factory setting Required setting
ZXDE ZXDI
G42 FnC Fans operating mode cn
cn = Switch on and off with the compressor, stop
during defrost
On = Always on, stop during defrost
cy = Switch on and off with the compressor, run
during defrost
Oy = Always on, run during defrost
S05 oA2 Relay output 2 nu = Not used EPF = Evaporator fan
G45 Fon Fan on time 1 min Adjust to application requirements
G46 FoF Fan off time 1 min Adjust to application requirements
G55 Fnd Fan delay after defrost 1 min Adjust to application requirements