October 2021
Service Manual
VCIOM-16909-EN Rev. 0
9
Section 3: Lubricant Recommendation and Requirements
Lubricant Recommendation and Requirements
3.4
Lubricant Points FQ
The table values given apply to re-lubrication in accordance with the re-lubrication intervals in the
operating instructions. After re-lubrication has been carried out, 2-3 full strokes must be performed.
If torque switch-off occur, the grease nipples must be removed, and the strokes repeated.
NOTE:
Lubricant can leak out of the lubrication points.
After that, the grease fittings should be installed.
At initial assembly or upon complete disassembly of the spindle nut is filled, all gears and bearings
pocketed filling. All moving parts as well as internal surfaces are coated to cover them.
•
Lubricant quantity according to expenditure.
•
Lubricant specification according to the operating instructions depending on the
temperature range.
Table 2.
Fuses on the Logic Board
Type
Lubrication Point (Quantity)
1
Main Gear
(cm
3
)
2
Bearing Spindle Drive
(cm
3
)
3
Intermediate Gear
(cm
3
)
FQ03
8
-
-
FQ06
18
-
-
FQ10
20
42
-
FQ20
20
68
29
FQ30
20
90
59
FQ50
20
80
90
Figure 2
Lubrication points
