Emerson ATCA-F120, Инструкция по установке и эксплуатации

Страница: 113 / 126

U-Boot Firmware
ATCA-F120 Installation and Use (6806800D06F)
113
5.8.1 POST Routines
The following table describes in detail which POST routines are performed.
Table 5-6 POST Routines
Device Description
CPU Check PLL configuration (PORPLLSR register).
Check device configuration (PORDEVSR register)
FPGA Register sanity check. The version code is checked. It must
not be 0x00 or 0xFF.
DRAM Address line and data-line test.
Switch devices The PCI interface is checked as follows:
z Check for configuration space access (vendor/device
ID)
z
Perform walking-one test on first memory-mapped
register
Base interface extender/SPI Data test on LED register page 0, offset 0x12
I2C buses Check whether bus addresses 0x31, 0x44, 0x46, 0x47,
0x50, 0x51 are accessible on bus 0 and 0x50, 0x70 on bus 1.
RTC Checks whether the second counter is advancing.
Compares the number of CPU ticks in one second against
the expected system clock frequency (66 MHz)
MDIO/PHY Attempts to read model and device ID from PHY address 0..
3
TSEC network port The PHY for each TSEC port is configured to loop back
mode, 100 and 1000 MBPS, and 10000 loop back packets
are sent and verified.
Boot flash Flash devices are sent into CFI query mode and the query
string is verified.
User (NAND) flash Check connectivity of NAND flash devices.
RTM Check connectivity of 10G repeater devices on RTM