Emerson ASTEC Helios Candeo AP6C75AA, Руководство по установке

Страница: 25 / 96

Locating and erecting the cabinets 25
Helios Candeo Power System – AP6C75AA Installation Manual
3 After drilling the hole, use the vacuum cleaner to clean all the wood chips and
dust in and around the hole.
4 Repeat steps 2 and 3 for every anchoring hole for the frame.
5 Repeat steps 2 to 4 for any other frame, if applicable.
–end–
3.3.2. Standard concrete floor anchoring
Standard concrete floor anchoring is that type used in non-earthquake areas. If
standard concrete floor anchoring is used, the anchors must be installed and set
now as described in the following procedure (refer to Figure 3.3) before erecting
the frame(s).
Procedure 3.4 – Installing and setting standard anchors in a concrete floor
Step Action
1 Drop the anchor into the hole drilled per Procedure 3.2.
2 Insert the appropriate setting tool into the anchor and hit it with a hammer to
expand the anchor until the collar of the setting tool rests against the shoulder
of the anchor.
3 Remove the setting tool.
4 Repeat steps 1 to 3 for every anchor for the frame.
5 Repeat steps 1 to 4 for any other frame, if applicable.
–end–
3.4. Erecting the frame(s)
CAUTION
Protect the equipment against damages when lifting.
If a Helios Candeo frame needs to be lifted by its top for
moving or locating purposes, the appropriate hardware and
method described below must be used in order to insure that
no damages are caused to the top of the frame. The same
method applies to lift the frame out of its shipping crate.
Each Helios Candeo frame is shipped with a stiffening bar and two lifting
eyebolts installed at the factory (see Figure 3.2). Do not remove, loosen or
replace these eyebolts and this stiffening bar until the frame is properly installed
and anchored to the floor at its final location. These eyebolts and stiffening bar
shall be reinstalled should the frame needs to be lifted by its top at anytime.