Press any key then hit enter to acknowledge the receipt of EULA
information:
Customer acceptance is required.
Note
An EMC representative should
not accept the agreement. If a customer is not present to
accept the EULA, press
Ctrl-C
to exit from the EULA acceptance screen and continue the
installation. Later, the customer can enter the
system show eula
command to
redisplay the EULA and accept it.
Run the configuration wizard
The CLI configuration wizard starts automatically the first time the system boots. The
wizard prompts you through a series of questions that provide just enough information
for initial system configuration and basic network connectivity.
Note
You can initiate the CLI configuration wizard manually by entering the
config setup
command.
Configuring the network
Procedure
1. Enter
yes
to begin configuring the system.
Do you want to configure system using GUI wizard (yes|no) [no]
:
yes
Answering
yes
initiates a shortened version of the CLI configuration wizard that
provides enough information to configure the system for network access. Afterward,
you can use the GUI (Data Domain System Manager) for additional configuration.
Answering
no
initiates a longer, more robust, version of the CLI configuration wizard.
2. Enter
yes
and change the password.
Note
If you are an EMC internal resource or partner, do not change the password unless
specifically directed to do so by the customer.
Change the 'sysadmin' password at this time? (yes|no):
3. Enter
yes
to configure the system for network connectivity.
Network Configuration
Configure Network at this time (yes|no)
[no]:
yes
4. Enter
yes
to configure DHCP to obtain network parameters (such as, the hostname,
domain name, and IP addresses) dynamically from a DHCP server. Or enter
no
to
configure the parameters manually.
Use DHCP
Use DHCP for hostname, domainname, default gateway and
DNS servers? (At least one interface needs to be configured
using DHCP) (yes|no|?)
EMC Data Domain DD2500 System Installation and Setup Guide
Run the configuration wizard
21
