EMC Connectrix ED-64M, Руководство пользователя

Страница: 150 / 476

5
5-22
Connectrix ED-64M User Guide
Configuring the Director
Click a checkbox to add or remove a checkmark. The default setting is
checked (LIN Alerts enabled).
To enable or disable LIN Alerts on all ports in the director, right-click
anywhere in the LIN Alerts column; then click Clear All LIN Alerts
or Set All LIN Alerts on the pop-up menu.
LINs are always logged in the Link Incident Log, regardless of the
configuration.
Refer to Link Incident Alerts on page 4-41 for more information.
Type
Open Systems mode only.
To select a port’s type (G_Port, E_Port, or F_Port), click this column to
display a drop-down list; then click the desired type.
To set all ports in the director to the same type, right-click anywhere
in the Type column; then click Set All to <port type> on the pop-up
menu.
In FICON mode, you cannot change port types unless the optional Enterprise
Fabric Extensions feature is installed. If ports are configured as E_Ports in
Open Systems mode, and you install Enterprise Fabric Extensions before
changing to FICON mode, the ports will remain as E_Ports when you change
to FICON mode. If Enterprise Fabric Extensions is not installed, setting a
switch to FICON mode changes all E_Ports to G_Ports.
Port Binding This setting determines whether Port Binding is enabled (if the box is
checked) or disabled on a port. Click a checkbox to add or remove a
checkmark.
◆
If enabled — The only device that can attach to the port is the one
specified by the WWN or Nickname in the Bound WWN column.
(If the Bound WWN column is blank, no device can connect to the
port.)
◆
If disabled — Any device can attach to the port, even if a WWN or
Nickname is specified in the Bound WWN column.
You can also enable or disable binding through right-click menus
(described later in this section) or through a Bind WWN dialog box
(described under Configuring Port Binding on page 5-24.)