10
EMC Departmental Switch DS-24M2 Installation Guide
Mounting the Slide Rails to the Switch
Mounting the Slide Rails to the Switch
This section describes how to mount the slide rail to the switch.
1.
Locate the left and right slide rails shipped with the kit. See
Switch Mounting Kit Parts List on page 3.
2.
On the left and right side of the switch, use the Torx screwdriver
shipped with the rail kit to remove the six Torx screws
(three
screws per side) that help hold the switch cover in place. (You
will be attaching the slide rails using these screws, so do not
discard them.)
3.
Attach the left and right slide rails to the switch with the
six Torx
screws you removed earlier as shown in the figure below. Be sure
to match up the vent cutouts on the sliding rail to the vents on the
switch and that the securing screw holes are on the same side as
the switches power supply.
Attaching Slide Rails to DS-24M2 Switch