EMC Celerra, Справочник по командам

Страница: 461 / 522

server_sysconfig
461
The server Commands
CAUTION
!
The speed and duplex settings on both sides of the physical
connection must be the same. Mismatched speed and duplex
settings can cause errors and impact network performance. For
example, if the duplex is set to half on one end and full on the
other, there might be network errors and performance issues.
rxflowctl= {enable | disable}
Enables the ability to accept and process pause frames.The
default is disable.
txflowctl= {enable | disable}
Enables pause frames to be transmited. The default is disable.
-virtual -delete [-Force] <device>
Deletes an Ethernet channel, link aggregation, or fail-safe network
device. Valid entries for a <device> are trk or fsn. The -Force option
is required if an IP address has been assigned.
-virtual
Information for all devices is displayed.
-virtual -info <device>
Displays information for the specified Ethernet channel, link
aggregation, or fail-safe network device.
-virtual -name <device> -create trk -option device=<device,...>
Creates a virtual device for trk (Ethernet channel or link aggregation).
An Ethernet channel can combine two, four, or eight (must be a
multiple of two) ports into a single virtual device.A maximum of
eight devices for Fast Ethernet is allowed.
◆
For Fast Ethernet trunking, use ana0 through ana7.
◆
For Gigabit Ethernet trunking, use ace0 and ace1.
◆
For Gigabit Ethernet using the NS series, use cge0 through cge5.
The -option string defines one or more devices for the Ethernet
channel or link aggregation. <device,...> specifies the device or
devices separated by commas. The -option string must have the
options separated with a space, and must be enclosed with double
quotes. If not, the command appears to execute, but does not pick up
any options not contained within double quotes.
A gigabit trunk can be created on more than two gigabit devices. The
Celerra Network Server has only two gigabit devices(ace0, ace1), so a