cod: Veronte-4-HUM.docx
pag: 9/20
3.3
Mechanical Mounting
M4 screws are recommended for mounting.
Figure 5: Veronte dimensions (mm)
Vibration Isolation
Although Veronte ultimately rejects noise and high-frequency modes of vibration with
electronic filters and internal mechanical filters, there might be situation where external
isolation components might be needed.
Veronte can be mounted in different ways in order to reject the airframe vibration. The
simplest could be achieved by just using a double-sided foam tape on the bottom side of
Veronte. Other ways may use some external structure which could be rigidly attached to the
airframe and softly attached to Veronte (e.g. foam, silent blocks, αgel, etc…).
Figure 6: Veronte Mounts
