21
5.5 CONTROLS
Before starting to work, all operators should famil-
iarize themselves with the location and function of
controls. This applies to all models.
5.51 ENGINE:
Read the engine manufacturers operator's
manual before starting for more detailed
instructions.
Ignition Switch:
This key operated switch controls the electric
power to the engine.
OFF
- Turn key fully counterclockwise to
stop the electrical system power and turn
the engine off.
ON
- Turn clockwise on detent to the run
position. This is the position where the
engine will continue to run.
START
-Turn fully clockwise to the last
spring-loaded detent position to
engage the starter solenoid and start
the engine. Release the key when the
engine starts and it will return to the RUN
position.
Choke:
This push/pull knob controls the position of
the choke. Pull the knob out to close the
choke for starting when the engine is cold.
Push the knob in to open the choke as the
engine warms. Always push the knob fully in
when operating the machine.
Oil Alert:
The Oil Alert system is designed to prevent
engine damage caused by an insufficient
amount of oil in the crankcase. Before the oil
level in the crankcase can fall below a safe
limit, the Oil
Alert indicator (red)
comes on and the Oil Alert system will auto-
matically stop the engine (the engine switch
will remain in the ON position).
Hour Meter
:
After starting the engine, the elapsed time of
the engine in use will be counted. It will not
count the elapsed time of the engine opera-
tion by just turning the engine switch ON.
HUF12000EA
HUF12000E
HOURS 1/10
Hour Meter
Oil Alert
Choke
Honda GX630
Control Panel
Ignition
