Babyhawk Race Pro 4 inch
7
emax-usa.com
1.Hold the bind button while powering on the receiver. When the GREEN LED is on,
it means the receiver is in BIND MODE
2.Turn on the transmitter, make sure it is set to D8 mode, and then set it into bind
status. When the RED LED of the receiver starts flashing, it means bind successful.
3.Turn on the transmitter again, the GREEN LED receiver will be on, it means the
receiver is receiving data from transmitter. Transmitter bind with receiver no need
repetitive operation, unless you change either receiver or transmitter.
Emax Babyhawk Race Pro 4 inch Flight Controller
(FC)
This flight controller has a F4 MCU with a MPU6000 gyro. Babyhawk Race Pro 4
inch flight controller comes pre-programmed and properly tuned for optimal flight.
The flight controller is programmed with Betaflight 4.0.2. For a full tune and
configuration setting file (CLI dump file) please visit
dump file.
Stock Flight Controller Settings
Babyhawk Race Pro 4 inch is configured to take a channel map of the TAER1234
convention. That is the channel map is in the respective order: throttle, aileron,
elevator, rudder, AUX 1, AUX 2, AUX 3, and AUX 4. The arm switch on Babyhawk
Race Pro 4 inch is set on AUX 1 and armed with the highest value. AUX 3 is
configured for the beeper in a high state. AUX 4 is set to Flip Over After Crash mode
(often referred to as turtle mode). Turtle mode is set when AUX 4 is in a high state.
Please configure your radio as described above or change these settings in
Betaflight Configurator.
PID profiles:
PID profile 1 is tuned and optimized for Babyhawk Race Pro 4 inch with the provided
Emax 4s 850 mAh battery for ultimate control.
Please do not change these values.
Rate Profiles:
Profile 1 is set to our determined rates
Adjusting Software Settings (Betaflight Configurator)
Betaflight Configurator can be used to changed programmed settings on Babyhawk
Race Pro 4 inch and to flash new firmware if desired. Betaflight Configurator and
flight controller firmware can be downloaded at
https://github.com/betaflight/
. The
hardware target for Babyhawk Race Pro 4 inch Flight Controller is MatekF411RX.
DISCLAIMER
: We do not suggest changing any PID settings on Babyhawk Race
Pro 4 inch or upgrading the firmware to new versions. Babyhawk Race Pro 4 inch
comes stock with an optimal tune for superior flight performance. Changing this can
affect flight time, overall speed, control of the aircraft, and excessive heat within the
motors.
Reprogramming Babyhawk Race Pro 4 inch Flight Controller
1. Put the Flight Controller in DFU mode by pressing the BOOT button while
plugging in the micro USB cable to a computer.
