eMagin Corporation
SVGA+ DRK User Manual
D01-500948-01 Rev A
Revision A
Interface & Design Reference Kit User
’
s Manual
5
Figure 5-2 Connection Orientation Illustration
Lift the display by its sides and take care not to press on the active area or leave fingerprint marks on
it. Position the display board such that the connectors match and the “J2” is in a normally readable
orientation. Insert the display into the Cable board.
5.2. Setup PC for Proper Video Output
•
The default compatible resolution is SVGA (800x600) with a refresh rate of 60 Hz. If you are
using this input set the video resolution for 800x600 in your PC’s display properties.
•
Ensure that the refresh rate to set to 60 Hz, or other supported refresh rate per the display
specification.
•
If you are using a laptop PC, you may need to export the video signal to an external monitor.
This is usually accomplished through a keypress including the Fn key + a designated function
key. See your PC’s operation instructions for more information.
•
If applicable, enable Stereovision 3D on your PC’s video graphics adapter.
5.3. Power Up
•
Slide the power switch to the ON position (slide away from the other switches).
Note: Power supplies with voltage spikes can damage the display. If using any input other than
the USB to power connection supplied with the system or the optional regulated AC/DC adapter,
