USER MANUAL - 2020
35
9.7 Stopping your motorcycle
To turn off the vehicule, follow the procedure below :
-
Remove the magnet switch from his support.
-
Switch off the battery (the LED around the battery switch
igniton will goes to OFF).
-
Unfold the kickstand so it is down and lean the motorcycle
on it. Make sure that the motorcycle is stable and on a hard
and stable ground to avoid falling. Beware of where you
park your motorcycle and if there is a slope or not, the
motorcycle having no gear to stop it moving.
Do not leave your motorcycle unattended after use.
After riding, some parts of the motorcycle may be hot, so be sure
not to touch them before they are fully cooled to avoid any risk of
burns.
9.8 Cleaning the motorcycle
The motorcycle must be cleaned with clear water. It is possible to
use soap to clean it.
To clean your motorcycle it is necessary to:
-
Wash the motorcycle without insisting on the components
vulnerable to moisture (electrical components, external
controls and external bearings).
-
Rinse the motorcycle thoroughly with clean water.
-
Dry the motorcycle, insisting on the electrical contacts.
Do not clean the handlebars directly with a high pressure
washer.
Take care that the charge battery cap is well install on the
charge connector on the battery.
DO NOT CLEAN THE MOTOR SENSOR WITH HIGH PRESSURE
WASHER.
DO NOT CLEAN THE BATTERY WITH HIGH PRESSURE WASHER.
DO NOT CLEAN THE CONTROLLER WITH HIGH PRESSURE
WASHER.
