EN
Please note:
The BioProTT
TM
Clamp-On SL is not galvanically isolated.
The BioProTT
TM
Clamp-On SLs perform without producing either unintended or excessive ultrasound output
or unintended or excessive surface temperatures according to
IEC 61326-1:2012.
Electromagnetic fields and
electrostatic discharge cannot lead to unintended changes of the electronics causing hazardous ultrasonic
output.
It is important to ensure that the BioProTT
TM
Clamp-On SL and the respective evaluation device
are not placed near any disturbance source that is not compliant with the applicable standards
since this could
–
influence and negatively affect the measurement.
–
impact the data stored on the sensor plug and permanently corrupt it.
Crossed lines and the use of extension cables might impact the data transfer and EMC
compatibility and/or negatively affet the measurement.
5.6 Maintenance and Service
The service for the BioProTT
TM
Clamp-On SL may be carried out by
em-tec GmbH only. If these instructions are not followed, em-tec GmbH shall accept no liability for the
component and the warranty will be void.
If you experience any trouble with the measurement despite following the user manual, or if your BioProTT
TM
Clamp-On SL is damaged in any way, please contact our service department. Make a note of the serial number
of the BioProTT
TM
Clamp-On SL and the evaluation device before you contact our staff.
If you need to return the BioProTT
TM
Clamp-On SL or the evaluation device for servicing, please follow the
steps below:
1.
Contact our service department at:
em-tec GmbH
Service Department
Am Graben 6-8
86923 Finning
Germany
2.
Our service department will send you a RMA form (=Return Merchandise Authorization).
3.
Fill out the form and include it in the shipment.
4.
Send your shipment to the address stated above.
BioProTT™ Clamp-On SL
Copyright em-tec GmbH
Page 9
D162-704 BioProTT™ Clamp-On SL – User Manual– V4.0
DocuSign Envelope ID: BE88571C-E493-4DFB-AF9A-864EB3FC3D75