ELZAB Prima 2, Руководство пользователя

Страница: 27 / 32

ELZAB S.A. User Manual PRIMA 2 scale
25
Function non accessible at the moment.
Bdna warto wprowadzonej danej.
Scale blocked. Report the fault to the service.
A/C converter error. You should remove the cause of interferences.
EEPROM memory error. Report the fault to the service.
FLASH memory error. The scale returns to factory settings.
Communication error on the SPI bus. Report the fault to the service.
Initiation of the FLASH memory after it was cleared up. Report the fault to the service.
7.2. Errors signalised acoustically
If the acoustic signal occurs when the display is switched off it means that:
Three consecutive single signals
(*---------,*---------,*---------)
USB interface communication error. The most common reason
of the error is lack of the virtual serial port driver installed on the
computer. This error is signalised after turning on the scale.
Three consecutive double signals
(-*-*------,-*-*------,-*-*------) To low power voltage (< 4,5V). Error signalized during
switching on or rest of the scale.
Three consecutive quadruple signals
(
-*-*-*-*--,-*-*-*-*--,-*-*-*-*--
)
To high power voltage (> 5,5V). Error signalized during
switching on or rest of the scale.
8. Conformity assessment (legalization)
Scales provided by ELZAB have undergone the conformity assessment procedure (legalization)
and are ready for use in the trade settlements in accordance with applicable law. Confirmations of
compliance with the above requirements are as follows:
1. large letter M on a green background placed on the scale nameplate,
2. set of metrological control characteristics, placed in accordance with the drawings set out
below,
3. compliance of the markup number placed on the nameplate with the markup number stored
in the non-volatile memory of the scale.
The markup number stored in the non-volatile memory of the scale can be checked any time, as
follows:
1. The scale should be in the weighing mode and indicate the weight kg.
2. Press the key and hold it until the displays shows the scale menu: .
3. Pressing the or key go to the menu item: .
4. Press the key. The display will show the markup number stored in the non-volatile
memory of the scale, e.g.: