Installation
29
© 2020, Elon Group AB. All rights reserved.
INSTALLATION
Follow the instructions in this section to install your machine.
WARNING!
•
If the power cord is damaged, it must be replaced by the manufacturer, the manufacturer’s service agent
or similarly qualified persons in order to avoid a hazard.
•
Use the new hose sets supplied with the machine. Do not reuse old hose sets.
•
To ensure your safety, connect the plug to an earthed three-pole socket. Check carefully to ensure that
your socket is properly and reliably earthed.
•
Make sure that the machine is connected to water and electrical supplies by a suitably qualified person in
accordance with the manufacturer’s instructions and local safety regulations.
CAUTION!
The inlet hose must be connected to the cold water supply.
Installation area
Keep the following in mind when choosing a location to install the machine:
• Avoid direct sunlight.
• Sufficient ventilation.
• Room temperature above 0 °C.
• Keep away from heat sources such as coal or gas appliances.
• The surface should be rigid, dry, and level. Stability is important to prevent the machine from wandering.
