WEP-2L. User manual
15
1.
a.
b.
c.
2.
a.
b.
1.
2.
4.2 Installing to false ceiling
1 – metal bracket; 2 – armstrong panel; 3 – plastic bracket; 4 – device.
Figure 9 – Mounting to a false ceiling
Fasten metal and plastic bracket on a ceiling as shown in the figure 9.
The plastic bracket (
3
) should be joined with the metal one (
1
) on the ceiling in the following order:
metal bracket -> armstrong panel -> plastic bracket.
Cut the hole in the armstrong panel. The size of the hole should be equal to hole of metal bracket.
Conduct wires through the hole.
Align holes in metal bracket with holes of armstrong panel and plastic bracket. Align together three
boltholes on the plastic bracket and the boltholes on the metal bracket. Screw the brackets to the
device surface by using a screwdrive.
Install the device.
Connect cables to corresponding connector of the device. Description of the connectors is given in
section 2.4 Design.
Align the device and plastic bracket together, fix the position, turning clockwise.
4.3 Removing the device from the bracket
For removing the device from the bracket:
Turn the device counter-clockwise, figure 7.
Remove the device.
It is not recommended to place the device inside a false ceiling as metal frame causes multipath signal
propagation and signal attenuation.
