WOP-12ac. Quick guide
7
•
•
•
•
•
•
•
5 SNMP service configuration
SNMP service configuration is performed in the
SNMP
section of the
Services
menu.
Restrict the source of SNMP requests to only the designated hosts or subnets
– check
Enabled
box.
Hostname, address, or subnet of Network Management System
– specify an IP-address of SNMP server,
from which SNMP commands will be transmitted. In the given example, IP address is
192.168.100.253
.
In the
Trap Destinations
section, perform the following settings:
Set the flag in the column with the
Enabled
heading;
Host Type
– specify whether the enabled host is an IPv4 host or an IPv6 host. In this example, IPv4 is
selected;
SNMP version
– select the version of the SNMP protocol. In this example, the
snmpV2
protocol is
selected;
Community name for traps
– set community name
public
.
Host name or IP or IPv6 Address
– check one of the fields for specifying traps receiver address and enter
an IP address of the device to which WOP-2ac will send traps. In the given example, IP address to
receive SNMP traps is
192.168.100.253
.
To apply a new configuration and save setting to non-volatile memory of the access point, click
Update
.
