WOP-12ac. Quick guide
15
•
•
•
•
9.3 Cluster configuration
In the
Cluster
menu, open
Access Points
tab and perform the following:
To edit the settings in the
Clustering Options
section, switch cluster mode to
Off
state.
In the
Clustering Options
section, perform the following configuration:
Location
– specify physical location of the access point. The option is used to analyze and control the
network in different monitoring tables.
“
Eltex
”
is used in the example;
Cluster Name
– set cluster name. The access point will be connected only to a cluster, which name is
specified in
“Cluster Name”
.
“
default
”
is used in the example;
Clustering IP Version
– select used IP version for management data exchange among access points in
the cluster.
“IPv4”
is used in the example.
Cluster-Priority
– set the priority of the device in the cluster. The access point with the maximum value of
this parameter becomes the Master point. If the parameter is not set, the access point with the lowest
MAC address becomes the master point in the cluster. To avoid a situation in which the master point of
the cluster will be re-elected, since an access point with a lower MAC address than that of the
configured point was included in the network, set the value of the parameter to
255
.
To apply a new configuration and save setting to non-volatile memory of the access point, click
Update
.
1.
2.
3.
The device may operate in a cluster only if WDS (Wireless Distribution System) and WGB (Work
Group Bridge) features are disabled.
For operation in a cluster Management Ethernet interfaces of all access points should be
located in one network.
Cluster operation mode is disabled by default.
