WB-15-W. User manual
12
1.
2.
3.
4.
5.
6.
7.
8.
1.
2.
3.
4.
a.
b.
c.
d.
5.
1.
3 Installation order
This section describes the safety measures, installation procedure and process of turning WB-15-W on.
3.1 Safety rules
Do not open the device case. There are no user serviceable parts inside.
Do not install the device during a thunderstorm. There is a risk of lightning stroke.
You must follow requirements for voltage, current and frequency specified in the user manual.
Measuring devices and computer must be grounded before connecting to the device. The electric potential
differnce between devices' cases should not exceed 1 V.
Make sure that all the cables are intact and they are reliably attached to connectors.
You should satisfy established standards and requirements for working at height during the device
installation on the high-rise constructions.
The device exploitation should be performed by specially prepared engineering and technical personnel.
Connect only to operational service equipment.
3.2 Installation recommendations
The recommended installation: communications mast/pole/wall.
Before you install and enable device, check the device for visible mechanical defects. If defects are
observed, you should stop the device installation, draw up corresponding act and contact the supplier.
Install the device on communications mast/pole/wall in the way that the Ethernet port is pointed down.
During the device installation to provide Wi-Fi coverage area with the best characteristics take into account
the following rules:
Install the device in the center of the intended wireless coverage area;
Do not install the device near (about 2 m) electrical and radio devices.
Use of radio phones and other devices, which work at 2.4 GHz, within the range of your Wi-Fi wireless
network is not recommended;
Obstacles in the form of glass/metal constructions, brick/concrete walls, water cans and mirrors can
significantly reduce Wi-Fi action radius.
When mounting the device, you should pay attention to the location of the towers of the cellular base
stations of providers whose SIM cards will be used in the device, and place the device as close to them as
possible (or, if you use a sector antenna, direct the antenna to the base station).
3.3 WB-15-W mounting
3.3.1 Pre-tuning
Before installing, proceed pre-tuning of the device:
Insert 1 or 2 SIM cards into the slot (as shown in the figure below). SIM1 is active by default.
