6
6. SETTING RUNTIME IN THE
GFA5 APP LATER
After setting the time on the actuator, check again the runtime setting in the
GFA5 app under
SETUP/ROOMS/ROOM NAME/DEVICE NAME
. This time should
be the actual runtime from bottom to top stopped with the push-button. It can
be changed and corrected at any time. The time entered should correspond as
closely as possible to the real runtime of the shading element; if in doubt, select
a slightly longer time.
Note the following relationships:
ɀ
If the set time is less than the real runtime, the shading element will not close
or open completely.
ɀ
If the set time is signifi cantly longer than the real runtime, there will be an
unnecessary delay in the end position/position message. In addition, the
positions approached will not correspond to the actual positions since the
basis for calculating the percentage control is the time stored in the app.
Set-up for shading actuators & GFA5
