8
Commissioning
Page 122
gas-lab
Q1
8.2 Parameterisation
Use a PC or laptop computer to create a complete parameterisation or to modify
existing parameters (except for a few). Create the parameter data record using
the parameterisation software GW-GNET+. The calibration switch has to be
open during the import of a complete parameterisation via DSS data interface.
Note:
Please refer to Chapter 6 for a brief description on the parameterisation
by means of the GW-GNET+ program. For a comprehensive description of the
parameterisation program, the GW-NET+ online help is available.
You may change operational parameters with GW-GNET+ via the data interface
even if the calibration switch is closed, provided the user locks are open.
Checking the settings
It is possible to check the complete set of parameter settings of
gas-net
devices
by means of the GW-GNET+ parameterisation program (for a brief description
cf. Chapter 4.3. You may observe the currently incoming measurements of the
connected sensor in a special menu at the device (for brief instructions cf.
Chapter 4.4).
The output signals supplied via the MFA6 output board(s) can also be indicated
for each channel via a special menu (see Chapter 4.4). This way it is possible to
check the output performance easily by comparing it with the physical data.
8.3 Sealing of the device (if applicable/when required)
It is possible and might be requiered according to local law to secure both the
sensor system and the evaluation computer of Q1 by adhesive stamps and
seals against forbidden change / opening. The sealing scheme can be found in
the annex. Please see documentation chapter 11.4 for more details.
8.4 Commissioning of Integrated RDT module
(optional feature for the European market and, not available
with all software variants)
If you need further information, please contact
your local agent.
Please see