Elster Instromet EK205, Руководство по эксплуатации

Страница: 38 / 71

38 Operation
6 Operation
Using the enSuite software and the data interfaces of the EK205, further
applications than those described below are possible. Instructions are available
at www.elster-instromet.com.
6.1 Safety
6.1.1 Personal protective equipment
When working on the device within a gas system, wearing personal protective equipment is
required to minimize health hazards.
 During the activity on the device, always wear the protective equipment required within
the relevant system.
 Always observe the notes on the personal protective equipment provided in the
working area.
6.2 Operating staff
Below various persons are stated who are authorized to perform various activities when
operating the EK205.
6.2.1 Trained individual
The person instructed to operate the EK205
 was instructed by the plant operator in an informational session on the tasks assigned
to him or her, and on possible hazards in case of improper behavior.
 is authorized to read and note values and parameters using operating elements of the
EK205.
6.2.2 Specialist
The specialist on operating the EK205
 has the ability, because of their technical training, knowledge and experience, as well
as their knowledge of the relevant regulations, to carry out the work to the device
assigned to them, and to recognize and avoid possible hazards on their own.
 is authorized to read and note values and parameters of the operating elements of the
EK205 and to make changes not subject to calibration requirements.
6.2.3 Calibration officer
The calibration officer
 has the ability, because of their technical training, knowledge and experience, as well
as their knowledge of the relevant standards and regulations, to carry out calibration-
protected work to gas systems. The calibration officer is trained to work with
calibration-protected devices and systems, and is acquainted with the relevant
standards and regulations that apply.

is authorized to read and note values and parameters of the operating elements of the
EK205 and to make changes subject to calibration requirements.