18
Setting the parameters
Cala KNX M-T push button
• Version: 13.09.2019 • Technical changes and errors excepted.
Dead man's switch:
The drive moves as soon as the button is pushed and stops as soon as the button is
released.
5.5. LEDs
Set the LED mode.
All LEDs as ambient lighting
If all LEDs are to be used as ambient lighting, illuminate all simultaneously. Set the
brightness of the LEDs, whether objects are used and whether the LEDs switch off au-
tomatically after pushing the button.
Point in time 0:
Push of button, start of time 1
Release before time 1 expired:
step (or stop if drive is moving)
Point in time 1:
End of time 1, start of time 2
Moving command
Release after time 1 expired
but before time 2 expires:
Stop
Release after time 1 + 2 expired:
Move into end position
Control mode
Comfort mode
Behavior during button operation:
Button is pushed and
released before time 1 expired = stop/step
held longer than time 1 = Up or Down
released between time 1 and 1-2= stop
released after time 1 +2 = no more stop
Time 1
0.0s ... • 2 s; 0.4 s
Time 2
0 s • 2 s; 2 s
Control mode
Dead man's switch
Behavior during button operation:
Push button = Up or Down command
Release button = Stop command
LED mode
• All LEDs off
• All LEDs as ambient lighting
• All LEDs individually controllable
LED mode
All LEDs as ambient lighting
Brightness
0 ... 100%; 30%
Time 1
Time 2
0
1
1 + 2
Fig. 4
Time interval comfort mode diagram
