Elsner 70156, Установка и настройка

Страница: 42 / 52

40 Parameter setting
Weather Station Suntracer KNX sl basic • Version: 26.08.2021 • Technical changes and errors excepted.
Block
If necessary, activate the switching output block and set what a 1 or 0 at the block entry
means and what happens in the event of a block.
The behaviour of the switching output on release is dependent on the value of the pa-
rameter "Switching output sends" (see "Switching output")
6.12. Computer
Activate the multi-functional computer, with which the input data can be changed by
calculation, querying a condition or converting the data point type. The menus for the
further setting of the computer are then displayed.
6.12.1. Computers 1-8
Set, in which cases input values received are to be kept per object. Please note that the
setting "After power restoration and programming" should not be used for the initial
Use switching output block No • Yes
Analysis of the blocking object • At value 1: block | At value 0: release
• At value 0: block | At value 1: release
Blocking object value before first call 0 • 1
Action when locking • Do not send message
• send 0
• send 1
Action upon release
(with 2 seconds release delay) [Dependent on the "Switching output
sends" setting]
Switching output sends on change do not send message •
Status object/s send/s
Switching output sends on change to 1 do not send message •
If switching output = 1

send 1
Switching output sends on change to 0 do not send message •
If switching output = 0

send 0
Switching output sends on change and
periodically Send switching output status
Switching output sends on change to 1 and
periodically If switching output = 1

send 1
Switching output sends on change to 0 and
periodically If switching output = 0

send 0
Computer 1 No • Yes
Computer... No • Yes
Computer 8 No • Yes