Elsner 70156, Установка и настройка

Страница: 29 / 52

27 Parameter setting
Weather Station Suntracer KNX sl basic • Version: 26.08.2021 • Technical changes and errors excepted.
Select whether the special rain output is to be used with fixed switching delay. This
switching output has no delay on rain recognition and 5 minutes delay after it is dry
again.
Set the delay times. If the delays are defined using objects, then the times set here are
only valid up to the first call.
Define the send pattern for the rain switch output and specify the object value for the
event of rain.
6.3. Temperature measurement value
First of all set whether the temperature sensor malfunction object is to be used and cor-
rect, if necessary, the output of the measurement value by specifying an offset (e.g. in
order to compensate malfunction sources).
Then set the mixed value calculation if desired.
Specify the send pattern for the total measured value.
Use rain output with fixed
switching delay No • Yes
Delays can be set via objects
(in seconds) No • Yes
Delay on rain none • 1 s … • 2 h
Delay on no rain
(after drying of the sensor) 5 min • 1 h… • 2 h
Switching output sends • on change
• on change to rain
• on change to no rain
• on change and periodically
• on change to rain and periodically
• on change to no rain and periodically
Send cycle
(if sent periodically)
5 s ... 2 h; 10 s
Object value(s) with rain 0 • 1
Use malfunction object No • Yes
Offset in 0.1°C -50… 50; 0
Use external reading No • Yes
Ext. Reading proportion of the total reading
(if external reading is to be used)
5% • 10% • 15% • ... • 50% • ... • 95% • 100%
All following settings refer to the total measured value
Send pattern • never
• periodically
• on change
• on change and periodically