elsner elektronik KNX RF-MSG-DST, Установка и настройка

Страница: 23 / 26

21 Parameter setting
Radio actuator KNX RF MSG-DST Version: 27.06.2018 • Technical changes and errors excepted.
4.3.2. Automation – external
The position storage for automatic movement is activated here. The pre-set position
can be overwritten at any time via a learning object. The memorised position can be
retrieved again at a later time. For configuration options, see chapter “Manual” on
page 20.
4.3.3. Scenes
A group address for scenes must be filed in the KNX system to control the scenes.
The input object ‘Channel X: call/save scenes’ of the actuator is linked to this group ad-
dress.
A scene is called , then the scene number is communicated to the actuator. The
movement position saved for this scene number in the actuator is then taken.
If the scene
saving function is used, then the current movement position is saved for
this scene number in the actuator.
The ‘Scenes’ menu item of the actuator is only shown if ‘Use scenes: yes’ was selected
in the settings for the drive channel. Every drive can
have up to 16 scene save
points for movement positions.
Activate a scene save point.
Assign a scene number to the scene save point. Use this scene number to call/save the
movement position stored in the actuator. Make sure that every scene number is used
only once per drive channel.
Use different positions for object values 0
and 1 no • yes
(if ‘yes’ is selected, there will be a division
into positions for object value 0 and object
value 1)
Position in % 0...100
Allow calling via command sequence: long-
term = 1, short-term = 1 no • yes
Use learning object for new position no • yes
Transfer when programming
(when learning object is used) • all parameters
• changed parameters only
Use scene save point X no • yes
Scene number 0...127